Specifications; Troubleshooting Guide - Health Zenith 4635 Instructions D'installation Et Mode D'emploi

Power Requirements ..................................... 120 VAC, 60 Hz
Lumens ......................................................... 360 LM
LED color temperature ................................ 2700 K
Electrical load - integrated LED .................. 9.0 Watts
SYMPTOM
The light will not come on.
The light comes on during the day.
The lights stay on continuously.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
CAN ICES-005 (B)/NMB-005 (B)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
209890-01

SPECIFICATIONS

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
1. Light switch is turned off.
2. Fuse is blown or circuit breaker is turned off.
3. Daylight turn-off (photocell) is in effect.
4. The circuit wiring is incorrect, if this is a new installation.
The light may be installed in a relatively dark location.
The light may be installed in a relatively dark location.
SOLUTION
1. Turn light switch on.
2. Replace fuse or turn circuit breaker on.
3. Recheck after dark or cover photocell with black
tape to test (see Testing, page 5).
4. Verify wiring is correct.
The light fixture is operating normally under these
circumstances. To test, shine a flashlight at the photocell.
The light should turn off.
The light fixture is operating normally under these
circumstances. To test, shine a flashlight at the photocell.
The light should turn off.
5