Klarstein BOTELLA 450 Mode D'emploi page 37

• Open the glass door and remove the two lock screws holding the door shaft
assembly to the glass door. Be careful to hold the glass door firmly after removing
the screws.
• Pull down to remove the glass door and place it on a padded surface to prevent
scratching it.
• Remove the two screws from the bottom left side of the door and fasten the screws
at the bottom right side of the door.
• Remove the right lower door hinge. And turn around 90°,then install it at the
designated position on the left side. And install the door shaft assembly accordingly.
EN
37