Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS CONTROL FUNCTIONS
- POWER
The POWER button supplies power to all of the functions
of the fireplace. The POWER button will put the insert in a
standby mode. This will turn off all functions and hold
the settings in memory. By pressing the POWER button
again the unit will turn onto the same settings.
NOTE:
Holding the POWER button on the control panel for
10 second will disable the heater function.
- FLAME
1. Pressing the FLAME button will turn on and off the flame
effect.
2. When pressing the FLAME button the display will
enter flame setting mode.
3. There are 6 flame settings that can be selected with the
▼▲ buttons.
- HEATER
1. Pressing the HEATER button will turn on and off the
heat function.
2. When pressing the HEATER button the display
will enter temperature setting mode.
3. When in temperature setting mode pressing the ▼ ▲
buttons will change the thermostat by 2 °F (1 °C.)
The temperature setting range is between 62 °F - 82 °F
(17 °C and 27 °C).
4. The default temperature is 72 °F (22 °C.)
NOTE: To change between °F and °C press and hold the
HEATER button on the control panel for 10 seconds.
NOTE: After the heater function or power is shutoff the blower will continue to run for several minutes to cool the
internal components.
- TIMER
1. Press TIMER button will turn on and off the timer settings.
2. When pressing the TIMER button the display will enter timer setting mode.
3. There are 10 timer levels (30 min, 1 hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H, 9H) that can be selected with the
▼▲ buttons.
REPLACING THE REMOTE CONTROL BATTERY
When the remote control stops operating or its range seems reduced, it is time to replace the battery with a
new one.
1. The battery compartment is located on the back end of the remote.
2. Press the small tab inwards as you slide the battery door open and remove the old battery.
3. Insert a CR2032 battery, checking that the "+" and "-" terminals of the battery matches the inside of the battery
compartment.
4. Replace the battery compartment door.
All manuals and user guides at all-guides.com
Figure 4
E-5
Figure 3
NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW
MEASURED PACE. PRESS THE REMOTE CONTROL BUTTONS
WITH AN EVEN MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.
Publicité
