DeWalt DW263 Traduction De La Notice D'instructions Originale page 28

EN GLI SH
Using a Nutsetter (fi g. 3)
DW263/DW264
1. For screws with sealing washers, turn the collar
(d) until the end of the nutsetter is flush with the
end of the depth locator.
If required, turn the collar until the nutsetter is
recessed approximately 2 mm into the depth
locator.
NOTE: ALWAYS refer to the screw
manufacturer's specifications for the proper
sealing washer settings in different applications.
2. Drive a screw into a scrap piece and check the
distance between the washer and the material.
3. Turn the collar (d) counterclockwise or clockwise
to decrease or increase the driving depth as
required.
4. Drive another screw and readjust the collar (d)
until the desired setting is achieved.
Depth Locator (fi g. 4)
DW263/DW264
This model is supplied with two depth locators (e) to
accommodate different bits, holders, sockets and
adaptors.
TO CHANGE DEPTH LOCATORS
1. Pull the collar (d) assembly off the tool.
2. Hold the depth locator (e) and unscrew the
collar (d).
3. Replace the depth locator (e).
4. To reassemble, proceed in reverse order.
Forward/Reverse Switch (fi g. 5)
WARNING: Always wait until the motor
has come to a complete standstill
before changing the direction of rotation.
Select the forward or reverse rotation by moving the
forward/reverse switch (c) in the direction indicated
by the arrows.
OPERATION
Instructions for Use
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: Always observe the safety
instructions and applicable regulations.
26
Proper Hand Position (fi g. 6)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main
handle (n), as shown.
For best results, hold the screwdriver with the
hand directly in line with the fastener and press
the variable speed switch with the last one or
two fingers of the hand, as shown. This reduces
the chance of the screw slipping from the drive
accessory when pressure is applied.
Screwdriving or Nutsetting (fi g. 1A)
1. Select the appropriate bit for the screw (or nut)
to be driven.
2. Select forward or reverse rotation as described
above.
DW263: For nutsetting, always use the correct
depth locator (e).
3. To run the tool, press the variable speed switch
(a). The pressure exerted on the variable speed
switch determines the tool speed.
NOTE: If necessary, press the lock-on button
(b) for continuous operation and release the
variable speed switch. The lock-on button
only works in full speed, forward and reverse
rotation.
To stop the tool in continuous operation, press
the switch briefly and release it.
WARNING: ALWAYS turn the tool
off when work is finished and before
unplugging.
4. To drive the screw, place it on the bit or into
the socket, press the variable speed switch
and push the screw into the workpiece with a
smooth, continuous motion. When the screw
is seated, a buzzing sound will come from the
front of the tool to indicate that the clutch has
disengaged.
5. To stop the tool, release the switch.