Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 4 rubber inserts Ø5
- 4 plastic washers Ø5
Fitting instructions
- Unscrew the 3 screws located on each side of the nose fairing, at the locations shown below :
- Place the Ermax supports over the nose fairing, then screw them with the 3 original screws on each side.
- Place the rubber inserts Ø5 on the Ermax supports, into the 4 holes provided for this purpose.
- Place the Ermax nose screen, and then secure it with the 4 screws BHC Ø5×20 and the 4 plastic washers Ø5.
Pay attention the nose screen is well placed before final tightening.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
- 4 screws BHC Ø5×20 black with big head
- 2 ABS supports
Original screws
« CAUTION »
FITTING INSTRUCTIONS
ERMAX NOSE SCREEN + SUPPORT
ADAPTABLE ON MT09 / FZ 9 2014 → ∞
Estimated fitting time : 30 min
Publicité
