Care And Maintenance - Avanti CIM102U3S Manuel D'instructions

Preparing the ice maker for long storage
If the ice maker will not be used for a long time, or is to be moved to another place, it will be
necessary to drain the system of water.
1. Shut off the water supply at the main water source.
2. Disconnect the water supply line from the water inlet.
3. Shut off the electric supply at the main electrical power source.
4. Take out the ice storage bin to remove any remaining ice and water. Dry the bin.
5. Pull off the drainage tube of the water trough to drain off all water.
6. Leave the door open to allow for circulation and to prevent mold and mildew.
7. Leave water supply line and power cord disconnected until ready to reuse.
IMPORTANT:
·
Do not touch the power plug when your hands are wet.
·
Never unplug the unit by pulling on the cord. Grasp the plug and pull out firmly.
Cleaning The Icemaker
If the ice maker is left unused for a long time, before the next use it
must be thoroughly cleaned. Follow carefully any instructions provided
for cleaning or use of sanitizing solutions. Do not leave any solution
inside the ice maker after cleaning.
Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. The
maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if
you have pets, or there are other special considerations.
Important Note:
Never keep anything in the ice storage bin that is not ice: objects like wine and beer
bottles are not only unsanitary, but the labels may slip off and plug up the drain.
Before proceeding with cleaning and maintenance operations, make sure the
power line of the unit is disconnected and the water line is shut off.

CARE AND MAINTENANCE

16