Shop-Vac SMK Serie Manuel D'utilisation page 8

L'aspirateur assistant pour l'atelier pour déchets secs/humides
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12. To remove the filter for cleaning, again hold the tank cover and turn the filter retainer counter-clockwise to loosen and remove.
FIGURE 13.
FIGURE 10
13. Slide the cartridge filter off the filter cage. FIGURE 14.
14. To clean cartridge filter shake or brush off excess dirt. FIGURE 15.
15. Or rinse (from the inside of the filter) with water. FIGURE 16. Dry completely (approximately 24 hours).
16. Check the filter for tears or small holes. If none are found, reinstall the filter. To prevent damage to your vacuum, do not use a filter
with a hole or a tear.
FIGURE 14
WARNING:
DEPENDENT ON THE FILTER. A CLOGGED FILTER CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE CLEANER. CHECK THE FILTER PERIODICALLY AND REPLACE AS REQUIRED.
INSTALLING DISPOSABLE FILTER BAG
WARNING:
BEFORE REMOVING THE TANK COVER.
17. Use the disposable filter bag in conjunction with the cartridge filter for easy disposal of the debris. The bag is not required for
normal dry pick up. When picking up fine dust or powders a high efficiency filter bag must be used.
18. With cord disconnected from the receptacle, pull latches in an outward motion and remove the tank cover.
19. Unscrew hose locking-nut and remove hose from inlet. FIGURE 17.
20. Remove the inlet defector from the deflector guide. NOTE: Hose must be removed before the inlet deflector can be taken
out. FIGURE 18.
21. Position the inlet deflector with the opening facing the left or the right side of the filter bag. Slide the filter bag collar over the inlet
deflector, matching the notches of the bag collar to the tabs on the inlet deflector. Bag will only fit properly one way. FIGURE 19.
22. Slide the inlet deflector with the filter bag attached into the deflector guide. FIGURE 20.
23. Reinsert hose into inlet and tighten the locking-nut. FIGURE 21.
24. When secured in place, expand the filter bag and position around the inside of the tank. Replace tank cover.
FIGURE 17
FIGURE 11
FIGURE 15
KEEP FILTERS CLEAN. EFFICIENCY OF THE VACUUM IS LARGELY
ALWAYS DISCONNECT THE
NOTE: USE FOR DRY PICK UP ONLY.
FIGURE 18
FIGURE 12
FIGURE 16
PLUG FROM THE WALL OUTLET
FIGURE 13
PAGE 7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Smk-sq6508891411

Table des Matières