Access Control Management; Safety Instructions - Auta PLACA FREE PROX Mode D'emploi

ACCESS CONTROL MANAGEMENT

Reset memory
Press for 5 seconds
until you hear a
series of beeps.
Users management
ADD users
Pass the MASTER card_key
fob on the reader.
The panel will emit 2
beeps and the LED will
turn BLUE.
1
ERASE users
Pass the MASTER
card_key fob on the
reader.
Panel will emit 2
beeps and the LED
will turn BLUE.
1
System states
Standby Correct opening User NOT authorised
WHITE LED 2 short beeps
2 BLUE flashes
MASTER card recording
Press 1 time, 1
short beep will
be heard.
The LED will turn
BLUE.
1
Pass the card_key fob, which we wish to configure
as MASTER, on the reader.
If the recording was successful, 1 long beep will be
heard.
If no card is passed within 10 seconds the panel will
return to standby.
THERE CAN ONLY BE ONE MASTER CARD PER
2
PANEL.
Pass the cards_key fobs, which we wish to add by the
reader. One by one.
Each correct recording will be heard 2 beeps.
If the keychain card we wish to add has already been
added, 3 beeps will be heard.
TO EXIT WAIT 10 SECONDS.
2
Pass again the MASTER Pass the USER card_key
card_key fob on the fob that we wish to
reader. remove on the reader.
Panel will emit 2 beeps The board will emit 2
and the LED will turn beeps.
RED.
TO EXIT
SECONDS
2 3
ADD users ERASE users
3 short beeps BLUE LED RED LED
2 RED flashes
5
GENERAL CONSIDERATIONS

SAFETY INSTRUCTIONS

Read and keep that manual.
The device installation process should be carried out by the qualified specialists.
Use the device
range.
Installation surface should be free from vibration and impact influence.
Keep this device far from open sources of heat, such as radiators, heaters, and ovens.
The device can be installed near other electronic equipment in case if the temperature of
the environment does not exceed previously mentioned range.
The device should be protected from the direct influence of the natural phenomena, such
as direct sunlight, rain or snow.
Don't use aggressive or abrasive detergent for the device surface cleaning.
Use soft wet cloth or tissue to remove strong dirt.
Attention!!
As a result of continuous upgrades and functionality improvements, technical characteristics of the
device can be changed without any preliminary declaration.
This manual can contain some inaccuracy or misprint.
The owner reserves the right to make corrections to the information described in the user manual
and device package.
NATURE PROTECTION
Don't throw away the device with other industrial or nutritive trash if you see that symbol.
Some regions have separation and recycling systems for the electronic equipment.
Connect with local authorities to receive information about recycling of electronic
equipment for your region.
RIGHTS AND LIMITATION OF LIABILITY
All rights reserved. Any part of that document can not be published in any form,
translated into other languages or reproduced in any way including electronic or
mechanical.
WAIT 10
Document recording and copying is strictly denied without owner permission.
from the –40 ˚C to +50 ˚C, always keep it within that temperature
6