Installation; Unit Mount - Auta PLACA FREE PROX Mode D'emploi

INSTALLATION

option 1 (POWER SUPPLY installed at panel) RECOMMENDED
1N4007
(12 Vdc 0.5A)
FTP CAT 5/6 (100% COPPER) 80m max.
Vi
CCTV 1
GND
GND
CCTV 2
Vi
Vi
GND
PANEL 1
AUDIO
PWR
Door1
Vi
GND
PANEL 2
AUDIO
PWR
Door2
option 2 (POWER SUPPLY installed at home)
1N4007
(12 Vdc 0.5A)
FTP CAT 5/6 (100% COPPER) 80m max.
Vi ONLY USED FOR
TO NEXT
DATA
SECONDARY MONITORS
GND MONITOR
(UP TO 3, Monitor FREE)
AUDIO
LAN
CCTV1/2 NET
+12
SUPPLY
-12
Power
Output
3
UNIT MOUNT. SURFACE MOUNT
1- Take the surface mount bracket from the kit and situate it 150-160 cm from the floor
line.
2- Mark and drill four holes in the wall.
3- Take four nuts from the kit and hammer them into the drilled holes.
4- Fix surface mount bracket on the wall by four screws from the kit.
5- Connect all communication wires and fix the door station on the surface mount
power
bracket by one bolt from the bottom side.
door 1
door 2
UNIT MOUNT. ANGLE BRACKET MOUNT
1- Take the angle bracket from the kit and situate it 150-160 cm from the floor line.
2- Mark and drill two holes in the wall.
3- Take two nuts from the kit and hammer them into the drilled holes.
4- Fix the angle bracket on the wall by the screws from the kit.
5- Connect all communication wires and fix the door station on the angle mount
bracket by one bolt from the bottom side.
power
door 1
door 2
4