Enclose; Packaging And Accessories - GIA giatsu ROMBO Manuel De L'utilisateur Et D'installation

Enclose: Explanation of the Error Codes
In the process of using, the display of the fire, wind and other patterns disappeared, because the
security device has been caused by action. Display flashing fault code shows that the failure of its
occurrence, the reason for the exception.
Fault code has been flashing when failure. On such occasions, please turn off the hot water value
and then open,or close / open the monitor, and then operate 1-2 times. If the display still show
the fault code, please be sure to close the water valve and valve, unplug the power plug, and
contact the after-sales service.
Error Code
01
10
11
12
13
32
40
50
51
60

Packaging and Accessories

Description
Gas water heater
Connector of gas inlet (with rubber seal ring)
Expansion screws
Mounting screws
User manual
Self-tapping screws
Flue duct（B
23
Inlet water temperature sensor breaks down
Detect a flame signal through pre-check
Normal combustion flames out accidentally
Thermostat fault protection
Fan or its drive circuit breaks down
Over high temperature protection（outlet）
Over high temperature protection（inlet）
Outlet water temperature sensor fault protection
type）
Explanation
Ignition fails
Fan blocking protection
Quantity
1 pc
1 pc
1 set
2 pcs
1 pc
2 pcs
1 set
57