GIA giatsu RA1A Manuel De L'utilisateur page 24

Buttons on remote controller
I FEEL button
Press this button to start I FEEL function and "
controller. After this function is set, the remote controller will send the detected ambient
temperature to the indoor unit and the unit will automatically adjust the indoor temperature
according to the detected temperature. Press this button again to close I FEEL function
and " " will disappear.
Note:
Please put the remote controller near the user and confirm the unit can receive the
remote code when this function is set. Do not put the remote controller near the object
of high temperature or low temperature in order to avoid detecting inaccurate ambient
temperature.
TEMP button
By pressing this button, you can see indoor seting temperature, indoor ambient
temperature or outdoor ambient temperature on indoor unit's display. The setting on remote
controller is selected circularly as below:
● When selecting "no display" on the remote controller, the temperature indicator which on
the indoor units will display the set temperature.
● When selecting "
displays indoor ambient temperature.
● When selecting "
displays outdoor ambient temperature.
Note:
Outdoor temperature display is not available for some models. At that time, indoor unit
receives " " signal, it displays indoor seting temperature.
CLEAN button
● Press this button to start or cancel clean function.
● It is unable to set clean function when the unit is on; if the air conditioner runs in cool or
dry mode before turning off, press "CLEAN" button and show "
is on; press "CLEAN" button again, "
running 10 mins in clean function then turn off automatically.
● In the first power on, the clean function is off acquiescently.
● The clean function can not be set and displayed when the air conditioner is in auto, fan
and heat mode before turn off.
No display
" with remote controller, temperature indicator on indoor unit
" with remote controller, temperature indicator on indoor unit
" will be displayed on the remote
" disappeared, then the clean function is off, or
7
" then the clean function