Buttons On Remote Controller - GIA giatsu RA1A Manuel De L'utilisateur

Buttons on remote controller

After connecting the power, the air conditioner will make a sound.
Power indicator is ON. After that, you can operate the air conditioner by using remote controller.
In state of turning on, pressing the button on the remote controller, the signal icon "
display of remote controller will blink once and the air conditioner will make a "beep" sound, which
means the signal has been sent to the air conditioner.The display will show the corresponding setting
function icons.
In state of turning off, light and clock icon will be displayed on the display of remote controller (If timer
on, timer off and light functions are set, the corresponding icons will be displayed on the display of
remote controller at the same time).
ON/OFF button
Press this button can turn on or turn off the air conditioner.
MODE button
Press this button to select your required operation mode.
When selecting auto mode, air conditioner will operate automatically according to ex-factory
setting. Setting temperature can't be adjusted and will not be displayed as well. Press
"FAN" button can adjust fan speed. Press "
angle.
When selecting cooling mode, air conditioner will operate under cooling mode. Press "+"
or "- " button to adjust set temperature. Press "FAN" button to adjust fan speed. Press "
" or " " button to adjust fan blowing angle.
When selecting dry mode, the air conditioner operates at fan1 under dry mode. Under
dry mode, fan speed can't be adjusted. Press "
angle.
When selecting fan mode, the air conditioner will only blow fan, no cooling and no heating.
Press "FAN" button to adjust fan speed. Press "
angle.
When selecting heating mode, the air conditioner will operate in heating mode. Press "+"
or " - "button to adjust set temperature. Press "FAN" button to adjust fan speed. Press
" " or " " button to adjust fan blowing angle. (Cooling only unit won't receive heating
mode signal. If setting heating mode with remote controller, press ON/OFF button can't
start up the unit).
Note:
● To preventing cold air, after starting up heating mode, indoor unit will delay 1~5 minutes to blow
air (actual delay time is depend on indoor ambient temperature).
● Seting temperature range from remote controller: 16~31
fan4, fan5, stepless speed.
Auto
Cooling Dry Fan Heating
" or " " button can adjust fan blowing
" or "
" or "
; Fan speed: auto, fan1, fan2 , fan3 ,
℃
4
" button to adjust fan blowing
" button to adjust fan blowing
"on the