Opera On - Opus Technologies OP-10R Manuel D'installation Et D'utilisation

OP-10R / OP-10T | Manuel d'installa on et d'u lisa on | Installa on and user manual | 21

5. Opera on

1) To switch on the units of the system, press
the bu on POWER (3). The POWER LED (4) will
show green. If it shows red, the ba ery is almost
discharged and should be recharged as soon as
possible. Whenever a bu on is pressed, the dis-
play (6) will indicate the transmission channel
adjusted for approx. 9 seconds, then the chan-
nel number will disappear. To reac vate the dis-
play for approx. 9 seconds, shortly press a
bu on on the unit.
2) Select a transmission channel from the 16
channels available ( frequency list a ached). Al-
ways set the transmi er and the receiver /
receivers of a system to the same channel. To
set the channel, keep the bu on CHANNEL (7)
pressed un l a LED starts flashing on the display
next to the channel number. Then press the
bu on CHANNEL repeatedly un l the desired
channel is indicated. When the LED on the dis-
play disappears approx. 6 seconds a er the last
actua on of the bu on CHANNEL, the channel