Atlantic SOLW2 Manuel Du Produit page 5

Maintenance
Replacement LED fixtures are available
for Hardscape Lights. Remove the screws
on the existing light, being careful not
to let the light strip fall, as this could break
the plug connecting the light to the cord.
Lower the light and squeeze the locking
clip; this will allow the plug to be separated.
Plug in the new light, making sure the
gasket has not moved or shifted and that
the notched edge of the light strip is
between the two ridges on the cord
gasket. Align the screw holes and hand
tighten the screws.
WIRING KITS - SOL30X4 / SOLW88X10
All SOL Warm White lights and wiring components connect via a 2 wire quick-connect plug
that is gasketed for outdoor use. Quick-connect plugs are not waterproof and should not
be submersed.
The SOL30X4 wiring kit enables up to four SOL Warm White lights (any models) to be
installed together and powered by a single 30 watt transformer. The transformer must
be plugged into a properly grounded GFCI outlet. Please follow the connection diagram
below for proper installation.
LIGHT #1
LIGHT #2
LIGHT #3
LIGHT #4
The SOL88X10 wiring kit enables up to ten SOL Warm White lights (any models) to be
installed together and controlled by a single transformer and timer. The transformer must
be plugged into a properly grounded GFCI outlet. Please follow the connection diagram
below for proper installation.
LIGHT #4
LIGHT #5
LIGHT #6
LIGHT #7
LIGHT #8
LIGHT #9
LIGHT #10
Transformer
SOLWSPL4
4-WAY SPLITTER
LIGHT #1
LIGHT #2
LIGHT #3
SOLWH06
30 Watt
SOLWEXT
20' EXTENSION
CORD
SOLWSPL4
4-WAY SPLITTER
SOLTRANS88
5