Installing The Handles - Cavavin C-73WBVC-V4 Manuel D'instruction

Installing the Handles

This beverage center includes 2 stainless steel handles. To install the handle please follow the below
instructions:
1. Remove the door gasket where the handle should be installed on the left side of the door, as
shown below. You won't need tool since the gasket can be removed by hand. You can start
with a corner if you can't remove it from the center.
2. Use the two handle screws, lock washer and flat washer included in the bag containing the
instruction manual and insert them into the side of the door from the inside to the outside.
3. Align the holes in the handle with the screws, tighten the screws using the screwdriver until the
base of the handle is at the level of the door and that the handle is tight but not too tight to
damage the assembly.
4. Replace the gasket the door in place.
1. Gasket
2. Flat washer
3. Lock washer
4. Screw
5. Handle
6. Door frame
22