Publicité
Les langues disponibles
Les langues disponibles
7.6. Automatic mode (Auto Mode)
The speed of the fans
(and thus the air flow) is
automatically controlled
according to the measu-
red air quality.
Each fan stage less redu-
ces the airflow by 25%.
(Level 4 = 100%/ Level 3=75%/
Level 2= 50%/ Level 1 =25%)
8. Filter change
1. switch off the unit, pull out the mains plug
and remove the back cover by hand.
2. remove the used filter; the filter can be
disposed of in the household waste.
3. clean the inner housing with a soft cloth.
4. install the new filter with the blue side facing
outwards.
5. close the lid.
6. the installation is complete.
7. The device must never be used
without a filter!
Note:
After changing the filter, press the
„FILTER RESET" key.
The maximum running time of 1,500 hours of
the replaced filter is thus correctly calculated.
The running time of the filters depends,
among other things, on the load of the air
sucked in and the speed of the fans and is
shown on the display.
9. Safety Instructions
9.1. To prevent damage due to overheating
of the air purifier, make sure that both the
air inlet and the air outlet are not covered.
9.2. Do not place the unit next to a heater, as
there is a risk of fire or deformation of the
cabinet due to heat.
9.3. Unplug the power cord when cleaning the
machine, replacing the filter or when not
using it for a long period of time.
9.4. Do not move the air purifier unless it
has been previously switched off.
9.5. Do not use the unit if the power supply
cable is damaged. In this case contact
your point of sale.
9.6. To prevent the appliance from wobbling or
tilting, ensure that the appliance is placed
on a level and non-slip surface.
9
EN
Publicité
