A.E.B. 553/2 Mode D'emploi page 14

Wires and components identification codes
1 BLACK WIRE: connect to the ground.
2 GREEN WIRE: only connect GAS electrovalves.
3 RED WIRE: connect + 12 Volt ignition on the coil together with the
RED wire of the switch.
4 BLUE WIRE.
5 RED AND BLACK WIRE: connect battery positive pole by a Min. 15A
or fuse Max. 20A.
6 Ground.
7 Fuse Min. 15A / Max. 20A.
8 Fuse Max. 7,5A.
9 Reduction unit and GAS electrovalves.
10 Change over switch.
11 To +12 Volt ignition of the coil or of the static coil group.
12 Connect to the BLUE wire of the switch, injectors' emulator
timing advance processor applicable.
13 +12 Volt ignition.
14 Coils group.
15 Green wire section 2,5mm +12 Volt ignition.
16 Round plug.
17 +12 Volt Battery.
18 GENERAL INSTALLATION.
19 With this connection, the switch no longer feeds gas electrovalves
because the Starting Protection does.
English IS553/2 REV. 230500-0