gala gar Smart Mig 250/1 Manuel Technique D'instructions page 11

1. GENERAL DESCRIPTION. TECHNICAL CHARACTERISTICS.
The Smart Mig 250/1 equipment allows electric welding by the semi-automatic MIG-MAG procedure of carbon
steels, weakly alloyed steels, stainless steels and aluminium, which are the most commonly used metals in
modern industry. This equipment is characterized by having the wire feeding system integrated with the power
source. The result is an equipment of easy installation and comfortable transfer to different workplaces.
SMART MIG 250/1
.
locksmithing and metalworking. Professional features with single-phase power supply.
Power supply voltage U1 (1Ph.- 60hz)
Maximum primary intensity (I1max )
Primary effective intensity (I1eff)
Continuous adjustment margin I2min- I2max
Maximum welding intensity I2max.
Rated welding intensity I2 60%.
Welding voltage U2min - U2max.
Number of staggerings U2
Drive system
Maximum wire speed.
Applicable wire diameters. (mm)
Digital Voltmeter-Amperimeter
ModePulse
Heat protection
Thermal insulation. – index of protection
Total dimensions
Weight.
1.1. ACCESSORY ELEMENTS.
The correct installation of the equipment as well as its adequate use implies the existence of a series of
accessory elements that must be chosen according to the table below.
2. TRANSPORT AND INSTALLATION.
knocks and sudden movements must be avoided when transporting the equipment. The position of the
transport will be the one referred by the indicative arrows on the packaging. The packaging must be protected
from water falling.
The welding equipment location must meet the following requirements:
Place: Dry and ventilated, far enough away from the cutting area in order to prevent the metal dust caused by
the cutting process from getting into the equipment.
MIG 250/1
2P 20 A -230V
 Power supply hose (RVK-1KV).
MIG 250/1
Length 230 V
10 m 2.5 mm
2
15-20 m 2.5 mm
2
Smart Mig 250/1. Instructions manual.
Single-phase connection equipment. Designed for continuous use in highly professional
TECHNICAL CHARACTERISTICS.
( ) mm.
ACCORDING TO EN 60974-1/ 10.
Accessories included as standard
Input cable.
Wire-drawing wheels
Gas Tube
Earth cable
400 V
1.5 mm
2
2.5 mm
2
Smart Mig 250/1
22300250
40 ÷250 A
250 A / 35 %
160 A / 60 %
30-38.4 V
12
4 R-Diam.30-Motor 24 V-
19 m/min
0.6-0.8-1.0-1,2 mm
STANDARD DIGITAL
2 T / 4 T
H (180º C) – IP-23S
800x440x770
68 Kg
DO NOT FORGET TO FIT THE EARTH
CONNECTION INTO THE PLUG.
230 V
37.2 A
22 A
50W
SI
11