Osburn 2500 (OP00025) Manuel Du Propriétaire page 20

3. Remove the stove ciment in the door corners (see dark spots in the figure below). When done,
reinstall the new glass.
Stove cement location
5. Put stove cement in the door corners, as shown on the image above.
6. Reinstall the glass door retainers making sure the stove cement is pressed down by the retainers.
Push the retainers towards the door frame to make sure there is no gag between the retainers
and the door frame and screw them in place. Do not over-tighten the screws as this will make the
glass crack under strong heat.
Push the retainers towards the door frame
8. Reinstall the door and wait 24 hours before using the stove again.
The replacement glass must be purchased only from an authorized dealer. Tempered glass or ordinary glass is
not suitable for high temperatures.
When changing the glass, make sure that the glass gaskets are in the same place as the originals to maintain
proper operation of the airwash system of the glass.
Page 20
Reinstalling the new glass
Operation Manual - 2500