Lionelo Aart Manuel De L'utilisateur page 10

HOW TO INCLINE THE CHILD SAFETY SEAT
The child safety seat can be positioned at three inclination angles and in the half-lying
position, suitable if the product is in a rear-facing position (fig. 13). To incline the child safety
seat, grab the lever below the seat and push the product in a desired direction. Release the
handle to secure the seat in position.
SEAT LINER AND LUMBAR SUPPORT
The liners are intended for the smallest children, improve their comfort and serve as additional
support. The lumbar support is designed for babies, you can remove it only when the child needs
more space in the child safety seat. The seat liner can be used until the child's weight exceeds 13 kg.
HOW TO ASSEMBLE THE CHILD SAFETY SEAT IN THE CAR
GROUP 0+, I (up to 18 kg)
For this weight group, the child safety seat is installed in a rear-facing position, in a backrest
half-lying position (fig. 14). The child is secured with child safety seat belts. Backrest position: 4.
1.
Place the child safety seat on the car seat. Make sure the product adheres to the car
seat backrest tight (fig. 15).
2.
Pull the car belt and carry the shoulder part through a blue guide (11) in the seat backrest. Next
carry the shoulder belt through the belt clamp (12), moving it back with your finger (fig. 16a).
3.
Carry the lumbar part of the car belt through the blue guide (18) in the base on both
sides of the product (fig. 16b).
4.
Fasten the belt and tighten it firmly, as much as possible (fig. 17a).
5.
Place the child in the child safety seat and secure it with child safety seat belts (fig. 17b).
GROUP I (9 - 18 kg)
For this weight group, the child safety seat is installed in a forward-facing position. The child
is secured with child safety seat belts. Backrest position: 1, 2, 3.
1.
Remove the lumbar support, and seat liner if necessary.
2.
Position the child safety seat on the car seat. Make sure the product adheres to the
car seat backrest tight (fig. 18).
3.
Carry the shoulder part of the car belt through the belt clamp (12), moving it away
with your finger (fig. 19).
4.
Carry the car belt through a red guide in the base on both sides of the child safety seat (17).
5.
Fasten the belt and tighten it as much as possible (fig. 20).
6.
Place the child in the child safety seat and secure it with child safety seat belts (fig. 21).
GROUP II and III (15 - 36 kg)
For this weight group, the child safety seat is installed in a forward-facing position. The child
is secured with car safety belts. Backrest position: 1, 2, 3.
1.
Detach the five-point belts of the child safety seat.
2.
Place the child safety seat on the car seat. Make sure the product adheres to the car
EN ‑ 10 ‑