Installing The Discs And Tools - Robot Coupe CL 55 e Notice D'instruction

STRAIGHT AND SLOPING TUBES HOPPER
This hopper consists of
two straight tubes with
a diameter of 75 mm
diameter, a 50 mm insert
and 2 pushers of 50 mm
and 70 mm. The insert
allows you to modify the
diameter of the tubes.
This hopper performs the same func tions as the
one described above with its straight tube. But it is
different in that it is equipped with a sloping tube
especially designed for slanted cutting.
No special tool is required to attach these hoppers
onto the disc.
• AUtOMAtIC feed-HeAd
This hopper is intended for continuous cutting tasks.
It is ideal for slicing
d e l i c a t e v e g e t a b l e s
such as mushrooms and
tomatoes, grating carrots,
s l i c i n g p o t a t o e s a n d
cutting french fries, to
mention but a few of its
uses.
This hopper is not suitable for certain specific tasks,
such as :
- slicing long vegetables (use the small opening in
the whole feed head).
- preparing bulky vegetables which are too big
to be fed into this hopper (use the pusher feed-
head).
Make sure that the agitator is in place, in order to
avoid blockages and variations in cutting quality.
It is vital that this tool be fitted each time the
automatic hopper is used.
Two types of tool are designed for the lever-type
hopper:
1) the agitator, which guides the
vegetables (except for cabbage)
towards the blades.
2) Introducing the vegetables too
quickly can result in a logjam. If
this occurs, clear the blockage
using the crank supplied for that
purpose.
Other tools, wands, spoons can
damage the machine so must not be used.
the crank serves to clear the machine if it becomes
clogged up with bulky vegetables.
InStAllIng tHe dISCS
And tOOlS
two ejection tools:
The CL 55 is supplied with two ejection tools. the
white ejector has been specially designed to cope
with cabbage. For all other vegetables, use the
black plastic ejector disc.
❶ With the motor unit
facing you, slot the
black discharge disk or
white ejection tool onto
the motor shaft and
check that it is properly
positioned at the bottom
of the bowl.
❷ position your chosen
disc:
a) If you have opted
for a slicing, grating or
julienne disc: position the
disc on the motor shaft. To
ensure that it is correctly
positioned, turn it in a
clockwise direction.
b) You have chosen a dicing unit:
i.e. a grid and a special slicing disc for diced
vegetables.
Slicing discs and dicing grids can be mounted in
the following combinations:
Dicing grid 5x5 8x8 10x10 14x14
mm mm mm mm
Slicer
• • • •
5 mm
• • • •
8 mm
• • • •
10 mm
• • • •
14 mm
• • • •
20 mm
• • • •
25 mm
You will find all the combinations marked
machines and accessories price list.
The dimensions of the dicing grid should always be
equal to or greater than those of the slicing disc.
20x20 25x25
mm mm
• •
• •
• •
• •
• •
• •
• on our
7