Troubleshooting - PAXXO Pactosafe 4.0 Traduction De La Notice D'instructions Originale

12. Troubleshooting

Fault Possible cause
The Pactosafe is not connected to a
mains socket
Switch not on.
Nothing happens when
No signal from foot pedal.
pressing the foot pedal.
The Pactosafe is starting up.
Battery discharged
Something is jamming the cog wheels
and is blocking the welding bars.
The feeding of the foil
works but not the
The welding bars are damaged.
welding.
Something is wrong inside the unit.
The welding bars are damaged.
Incomplete welding of
the foil. See picture in
Section 10.
Something is wrong inside the unit.
The welding of the foil
is too powerful. See Something is wrong inside the unit.
picture in Section 10.
The foil is adhering to
The welding bars are damaged.
the welding bars.
Waste is stuck
between the welding
bars.
If the error remains, contact the distributor/manufacturer. The plug-in units are repaired and
delivered in tailor-made boxes. When ordering, a newly repaired plug-in unit is sent with
replacement instructions, and the defective plug-in unit should be returned in the same box.
5410 Funnel Wide
5424 Power adaptor
5617 Power cable
5426 Battery charger
5428 Battery pack
543WS Plug-in unit
543WM Plug-in unit with battery
5524 Knobs
5602 Foot pedal
Wing nuts for legs
Paxxo AB / Bjurögatan 35, SE-211 24 Malmö, Sweden / Tel: +4640186025/ Fax: +4640183736 /www.paxxo.com
Action
Connect the Pactosafe to a mains
socket.
Turn on the switch.
Check its connection and whether it is
damaged. Shorten or replace if
necessary.
The system takes 5 seconds to
become operational.
Charge battery
Remove the item causing the
blockage.
Contact the distributor/manufacturer.
Contact the distributor/ manufacturer.
Contact the distributor/ manufacturer.
Contact the distributor/ manufacturer.
Contact the distributor/ manufacturer.
Contact the distributor/ manufacturer.
Switch the unit OFF and then ON
again. The Pactosafe will then return
to its start mode.
ON / OFF Switch
Connection to foot pedal
14