Onni Care TWINKLE Manuel De L'utilisateur page 7

You can take a picture of your baby or upload a picture from your
phone, or add a picture later. Add the baby's name and other
information, and click "Save". You can come back to this page at
any time from the "My Babies" list.
SETTING UP THE MONITOR
Make sure you have your phone connected to a 2.4GHz WiFi
network before plugging in Twinkle.
Once plugged in, the signal light will start a sequence. When the
signal light is flashing green, go back to the app in your phone.
(Log in if needed.)
Press the "MONITOR" tab and Select "Set up Twinkle".
Scan the QR code from the device using Onni Baby app.
If you want, you can edit the monitor name (for example: Baby's
room). Select "Save" to proceed.
Enter your WLAN password. The default WLAN is the one
you have active on your phone. If you want to use another
available WLAN network, first connect your phone to that
network and then switch on the monitor, after it's ready for new
WLAN setup, you will see flashing green signal light. Then go to
"Monitor" tab in your app and click "settings" link. That will open
the WLAN setup view to add WLAN password.
Click "Save", and your new Twinkle will be connected to the baby
profile you've just created. Once Twinkle's signal light turns flat
green, you can start monitoring.
NOTE: We recommend using WPA security types. WEP
security type doesn't work with all routers, and if the SSID
names contains spaces (example: home router), the connection
can fail. If your router is set for enabling MAC addresses or auto
channel selection, you may experience some difficulty in setting
up Twinkle. If that's the case, disable MAC address filtering and
try selecting 2.4 GHz band on your router and assign a fixed
channel (11).
7