Setting Up The Monitor - Onni Care ASTRO Mode D'emploi

All manuals and user guides at all-guides.com
You can take a picture of your baby or upload a picture from your
phone, or add a picture later. Add the baby's name and other
information, and click "Save". You can come back to this page at
any time from the "My Babies" list.

SETTING UP THE MONITOR

Make sure you have your phone connected to a 2.4GHz WiFi
network before plugging in Astro.
Once plugged in, the signal light will start a sequence. When the
signal light is flashing green, go back to the app in your phone. (Log
in if needed.)
Press the "MONITOR" tab and Select "Set up Astro".
Scan the QR code from the device using Onni Baby app.
If you want, you can edit the monitor name (for example: Baby's
room). Select "Save" to proceed.
Enter your WLAN password. The default WLAN is the one you
have active on your phone. If you want to use another available
WLAN network, first connect your phone to that network and
then switch on the monitor, after it's ready for new WLAN setup,
you will see flashing green signal light. Then go to "Monitor" tab in
your app and click "settings" link. That will open the WLAN setup
view to add WLAN password.
Click "Save", and your new Astro will be connected to the baby
profile you've just created. Once Astro's signal light turns flat
green, you can start monitoring.
NOTE: We recommend using WPA security types. WEP security
type doesn't work with all routers, and if the SSID names contains
spaces (example: home router), the connection can fail.
If your router is set for enabling MAC addresses or auto channel
selection, you may experience some difficulty in setting up Astro.
If that's the case, disable MAC address filtering and try selecting
2.4 GHz band on your router and assign a fixed channel (11).
7