JumpTek 084-6692-6 Guide D'assemblage, D'utilisation Et D'entretien page 11

ASSEMBLY
Repeat the steps above to attach all six Supporting Poles onto the vertical legs of the trampoline.
•
After completing the assembly, the Supporting Poles should look like the illustration below.
•
Step 11: Assembling the Enclosure Net
Note: The edge with pre-sewn loops is the upper part of the Enclosure Net.
Locate a position for the entrance of the trampoline and hang the pre-sewn loop closest to the opening
•
onto the Ball Cap (2).
Hang the rest of the pre-sewn loops around the remaining five Ball Caps (2).
•
Attach the bottom end of the Enclosure Net (1) to the trampoline bed using the existing bed springs.
•
Align the eyelets of the Enclosure Net (1) with the V-rings of the bed and untie one of the springs using
•
the hook tool.
Note: It is essential to select the closest eyelet to its respective V-ring. Even small
misalignments may cause problems with proper assembly.
11