JumpTek 084-6692-6 Guide D'assemblage, D'utilisation Et D'entretien page 10

ASSEMBLY
Step 8: Attaching the Foam Sleeve
Insert the assembled Upper and Lower Supporting Poles (9, 17) into the wider opening of the Foam Sleeve (19).
•
Slide the assembled poles in until the top end of the Upper Supporting Pole (17) comes out on the opposite
•
side.
Make sure that the Sleeve (19) covers the entire preinstalled foam of the Supporting Poles.
•
Step 9: Affixing the Ball Cap
Place a Ball Cap (2) onto the top end of each Upper Supporting Pole (17). Make sure that the screw hole on the
•
Ball Cap (2) is aligned with the screw hole on the top end of the Pole.
Fasten the Ball Caps (2) using the Ball Cap Screws (3).
•
Step 10: Affixing the Supporting Poles to the Trampoline Legs
• Connect the Lower Supporting Poles (9) to the trampoline by inserting them into each of the Welded Sockets.
• Secure each Lower Supporting Pole (9) with a Hex Bolt (14) and Nut (13) using Allen Key (21).
10