Cabling; Default Settings - Atlantis Land A02-RA110 Guide D'installation Rapide

ENGLISH

1.4 Cabling

First you must connect the product to the ADSL line through the
RJ11 cable you have in equipment (in the port LINE), then
connect to the RJ45 ports the PCs of your Lan or others Switch.
Once you've checked all the connections and you've turned on the
Compact Router ADSL the product will carry on immediately a
diagnosis (20 seconds). Finished this the Led POWER and SYS
(eventually even the Led LAN, if connected to PCs) will be fixed
green. The Led ADSL, if suitably connected, at first will be
flashing , during the ranging process and then it will remain fixed
(necessary condition for using the Internet).

1.5 Default Settings

The Compact Router ADSL can be configured with your Web
browser. The web browser is included as a standard application in
following operation systems, UNIX, Linux, Mac OS, Windows
95/98/NT/2000/Me, etc. The product provides a very easy and
user-friendly interface for configuration.
Before Configuration
This section describes the configuration required by LAN-attached
PCs that communicate with the Compact Router ADSL, either to
configure the device, or for network access. These PCs must have
an Ethernet interface installed properly, be connected to the
Compact Router ADSL either directly or through an external
repeater hub, and have TCP/IP installed and configured to obtain
an IP address through a DHCP server or a fixed IP address that
must be in the same subnet of the Wireless ADSL Router. The
default IP address of the Compact Router ADSL is 192.168.1.254
and subnet mask is 255.255.255.0. The best and easy way is to
configure the PC to get an IP address from the Compact Router
ADSL.
Please follow the steps below for PC's network environment
installation. First of all, please check your PC's network
22