ALDEN SPS 130 AGM Mode D'emploi page 5

Only make direct connections. Never use other terminal blocks or existing electrical circuits.
The regulator has to be put as near up to the battery as possible, sheltered from impacts and humidity.
Use the provided black cable
*
or
a black cable 2 x 2,5 mm
Connect with the provided
thermofusion fittings or with
solderless terminals
Use the provided
or a blue cable 2 x 4 mm
How to read the indicator leds :
(green): battery full.
100%
(green): battery charging.
20%
These leds can be switched on at the same time, which means that the battery is almost full but continues to load.
IF THE INSTALLATION IS NOT DONE ACCORDING TO THESE INSTRUCTIONS.
Installation diagram
The fuse has to be put as near up to the battery as possible.
Place the switches as indicated on the
diagrams according to the type of battery.
blue brown
Use the provided
TOIT
2
Use the provided
blue cable
*
2
ALDEN DECLINES ALL RESPONSIBILITY
ALDEN SPS 130 AGM - 080429 - 5
ACIDE
Régulateur / Regolatore / Regler
connection
Compatible /
Compatibile /
Kompatibel :
Sunpower System
SolarWatt
forked terminals
Use blue cable 2 x 4 mm
(max. 2 m. long)
Obligation
:
Protect with a 10 Amp fuse
Optional Temp.
Sensor
Optional Volt/
amp display
T T
W/Ah
100%
AGM GEL
20%
Digital
SPS 130
130 Wp
Kéops
® 12 V
Louxor ®
®
8,2 A
®
Girasol ®
Dakar ®
12 V START
Obligation
.
2
Towards the + input
of the start battery
blue brown
cell-battery
* : not delivered with regulator alone.
:
Protect with a
3 Amp fuse