auna PRO MIC-900 Mode D'emploi page 13

EN
NOTES ON ASSEMBLY AND USE
To achieve the desired sound, test different positions to the sound source.
Move the microphone quietly around the recording room and test different
distances and angles. Only when you have reached the right basic tone
should you use equalisers and sound processors.
Because of the microphone's extremely linear frequency response and high
sound resolution, "EQing" should not be necessary for high frequencies. This
only influences the input signal too much and increases the interference tone
unnecessarily. The microphone has the clarity needed for recording and mi-
xing.
The microphone has an adapter that fits European and American micropho-
ne holders. Detach the adapter from the microphone, attach it to the micro-
phone holder and then fix the microphone on the adapter. The microphone
should be mounted upright and the sound should hit it at a right angle. Test
different positions until you achieve the desired sound. If necessary, you can
also adjust it vertically with the hinge.
NOTE: Handle the microphone and the adapter with care. Do not subject the
threads to excessive force.
Of course, you can also mount the microphone without this adapter on a
suitable microphone stand purchased by you.
Sing/speak into the front (printed with auna logo) of the microphone for best
results:
13