Apply Power At Source; Verify Successful Installation - Ketra G21210BTGR33AWH/BK Manuel D'installation

I N S TA L L AT I O N
Black conductor goes to "L" terminal.
-
White conductor goes to "N" terminal.
Green conductor goes to "
Red conductor goes to "S" terminal.
Note: Conductor colors are not always as listed. These colors vary depending on your wiring setup.
• • Open appropriate terminals by flipping orange levers into UP position. Open appropriate terminals by flipping orange levers into UP position.
To ensure the correct wiring, consult a professional electrician.
(see fig. 5) (see fig. 5)
For additional information, refer to the N3 Satellite product installation guide.
5 5
fig. 7
• • Make connections to the "Power and Signal Out" section; connecting Make connections to the "Power and Signal Out" section; connecting
to appropriate line, neutral, and ground terminals. (Note: wire strip to appropriate line, neutral, and ground terminals. (Note: wire strip
length is 12mm/.47inches.) length is 12mm/.47inches.)
S T E P 4

Apply Power at Source

• • Insert appropriate conductors from Mains Power. (see fig. 6) Insert appropriate conductors from Mains Power. (see fig. 6)
Black conductor goes to "L" terminal. Black conductor goes to "L" terminal.
1. Refer to the N3 Satellite product installation guide for instructions to apply power to N3 Satellite.
White conductor goes to "N" terminal. White conductor goes to "N" terminal.
S T E P 5

Verify Successful Installation

Green conductor goes to " " terminal. Green conductor goes to " " terminal.
Red conductor goes to "S" terminal. Red conductor goes to "S" terminal.
1. Apply power to circuit.
If data is present at G2 Linear control port, appropriate LED will indicate status.
-
Green "Power" LED on N3 Satellite will illuminate indicating successful installation and
-
product functionality.
If data is present at G2 Linear control port, appropriate LED will indicate status. Note: Conductor colors are not always as listed. These colors vary Note: Conductor colors are not always as listed. These colors vary
-
depending on your wiring setup. To ensure the correct wiring, consult a depending on your wiring setup. To ensure the correct wiring, consult a
2. Disconnect power and install cover of N3 Satellite.
3. Restore power and configure device using the design software.
• • For additional information, refer to the N3 Satellite product For additional information, refer to the N3 Satellite product
installation guide. installation guide.
P/N 3662343 Rev B
© 2019 Ketra, Inc. All rights reserved.
I N S TA LL ATI O N I N S TA LL ATI O N
" terminal.
6 6
professional electrician. professional electrician.
fig. 8
11 | G2 INSTALLATION GUIDE