Me BELL-510 RX Mode D'emploi page 19

ally respond. The radio doorbell plays a ring tone and automatically leaves the
learning mode.
This procedure must be repeated for each additional transmitter. A maximum of
4 transmitters can be taught in.
SETTING THE VOLUME
The volume can be adjusted in several steps via the two keys Plus (4) and Minus
(5). Briefly press the Plus key to increase the volume one level or the Minus key
to decrease the volume one level.
SETTING THE COLOUR OF THE LIGHT PANEL
The colour of the light panel is set with the colour selection key (6). A total of 7
different colours are available. Each press of the key changes to the next colour.
The last colour played back is automatically saved.
REPEATER FUNCTION
The radio doorbell has an integrated repeater function, i.e. it can forward radio
signals from several transmitters of the Bell series and thus increase the range of
the transmitters.
It is not necessary for the Bell transmitter to be tuned in to the radio doorbell in
order to be forwarded. The repeater function is always active and cannot be
switched off.
Bell transmitters that are tuned in to the radio doorbell are also forwarded. The
radio doorbell itself, however, only rings for transmission signals that have also
been tuned in to the radio doorbell.
This makes it possible, for example, for the radio doorbell in a two-family house
to ring only when the bell button for family 1 is pressed. The radio signal of the
bell button for family 2 is only forwarded without the radio doorbell itself ringing.
Note: There is a time delay of approx. 3 seconds between the reception of the
signal until it is forwarded. The control LED indicates a forwarding by briefly
lighting up.
19
BELL-510 RX
ENGLISH
GB