Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DANGER:
ORTO-ALRESA is not responsible for the injuries which may cause the spare parts which are not the original ones. Use
only original spare parts.
Before to proceed please unplug the centrifuge
The replacement will be settled when speed indicator change its value frequently.
- Take out the rotor as indicated on point 5.4 of this manual .
- Release the motor rubber protector. Screw off the six screws of the holder of the motor protector ring.
- On the motor you will find the RPM sensor on a plate with three wires.
- Take out the front of the centrifuge with a Phillips key and unplug the three wires of its connector. Then screw off the
fixing screws.
- Replace or clean with alcohol.
- Place the RPM sensor. Please pay attention to fit it carefully and do not touch the motor disc. You can check it turning
the axis with your hand and checking that there is not any friction noise. Screw on.
- Plug the wires to its connector, close the front and place the screws of the motor rubber protector ring.
-Fit the rotor as indicated on 5.4 point of the manual.
MANUEL DE L´UTILISATEUR
29
Publicité
Table des Matières
