Technical Data - Gartenmeister AAS 4025 Mode D'emploi

Cordless Telescopic Pruner AAS 4025

Technical Data

Battery voltage/operation voltage
Guide Bar
Chain
Guide Bar Type
Speed
Battery type
(not included in the scope of delivery)
Voltage / battery capacity / energy
Charging device
(not included in the scope of delivery)
Runtime max.
Angle at which the motor can be set
Tool length
Weight
(without guide bar and chain)
Oil
Sound Pressure Level L
Measured sound power level L WA
Vibration
Technical changes are reserved.
Emissions
- The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specified vibration emission value can also be necessary for the assessment of work breaks are used.
- The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks
- Try to keep the stress due to vibration as low as possible. For example, measures to reduce vibration stress are
wearing gloves when using the tool and limiting the work time. All phase of the operating cycle must be considered
in this regard, (for example, times when the power tool is switched off, and times when the power tool is switched
on but is not running under load).
GB | Operating Instructions
pA (2000/14/EG)
40 V DC
250 mm / 10"
91P040X
100SDEA318 Oregon
4,5 m/s
R3-360-AH-U-01 / R3-360-AH-U-02
Li-Ion 40 V / 2,5 Ah / 100 Wh
R3-360-3A-02 Quick charger
R3-360-1A-02 charger
ca. 95 Min.
from -45° to 22,5°
from 2.10 m to 2.80 m
3,9 kg
3
70 cm
86,7 dB(A) [
K 3,0 dB(A)]
97,4 dB(A) [
K 3,0 dB(A)]
[
< 2,5 m/s K 1,5 m/s
2
2
2
]