Black & Decker D3300 Mode D'emploi page 4

H OW TO US E
This product is for household use only.
GET TI NG STARTE D
• Remove all labels, tags and stickers attached to the body, cord, or
soleplate of the iron.
• Remove and save literature.
• Please note that water droplets may still be visible in the tank at the time
of purchase. This is from the individual quality tests done to ensure that
every iron meets our high standards for product performance.
FILLING THE WATER TANK
1. With the iron on a flat surface with the soleplate down, open the
water-fill cover.
2. Using a clean measuring cup, pour water into opening until water
reaches the "MAX" level mark on the side of the water tank. Do not
overfill. Close the water-fill cover securely.
3. Stand the iron on the heel rest.
4. To refill at any time during the ironing process, unplug the iron and
follow the above procedure.
USING YOUR IRON
1. Plug the iron into an outlet. The red power/auto off light will
illuminate under the handle, indicating that the iron is heating.
2. Read the manufacturer fabric labels for material content and
clothing care recommendations to help select the correct
temperature and steam settings.
3. Select the temperature on the iron by turning the temp dial until
you've reached the desired setting based on the fabric type:
synthetic, nylon or silk, polyester, blend, wool, cotton or linen.
4. Allow the iron about 2 minutes to heat up to the desired temperature.
5. To dry iron (without steam), it is not necessary to empty the water
tank; simply move the variable steam control all the way to the left
on the dry iron setting.
•
6. To iron with steam, push the variable steam control to the desired
amount of steam. For optimal results, the steam settings should be
used with the following temperature settings.
•
•
•
4
NO steam: synthetics, nylon, silk, polyester
Low steam: blends
Medium steam: wool
High steam: cotton or linen