Télécharger Imprimer la page

Renkforce RF-CCB-200 Mode D'emploi page 3

Fiche allume-cigare avec haut-parleur bluetooth

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions
RF-CCB-200
Car Charger with Bluetooth Mono Earphone
Item No. 2176934
Intended use
The product is intended to be used as an adapter to power or recharge mobile devices and
incorporates a Bluetooth earpiece. The charger has an integrated receptacle for recharging
and stowing the earpiece. The product is powered by a car cigarette lighter socket.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture must be avoided
under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged. In
addition, improper use can result in or other hazards. Read the instructions carefully and store
them in a safe place. Make this product available to third parties only together with its operating
instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Car charger with Bluetooth earpiece
Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads or
scan the QR code shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the exclamation mark in the triangle is used to indicate important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
a) General information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous
playing material for children.
• Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, steam and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it
from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can
damage the product.
• Consult an expert when in doubt about the operation, safety or connection of the appliance.
• Maintenance, modifications and repairs must only be completed by a technician or an
authorised repair centre.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
• Do not use the product when driving a vehicle, operating machinery or performing any
other potentially dangerous activity. You may not hear warning signals and, as a result, be
exposed to hazards.
• If you use the product when playing sports or as a pedestrian, adjust the volume so that you
can still hear environmental noises.
• Do not listen to music at an excessive volume for prolonged periods. This may damage
your hearing.
b) Connected devices
• Also observe the safety and operating instructions of any other devices which are connected
to the product.
• Operating instructions
Operating elements
1
1 Plug
2 Charger LED
3 Earpiece receptacle
4 Ear tip
Getting started
1. Insert the charger power plug (1) into the car cigarette lighter socket.
2. The charger will receive power after the car ignition switch is turned on.
The charger LED indicator (2) will light up if the charger is receiving power.
Charging
You can operate the product while the engine is both on or off. But you should not
start the engine while the product is connected, since the cigarette lighter socket
disconnects during engine start (not necessarily applicable to all vehicle models).
If the engine is switched off, drawing current over a longer period of time will
discharge the vehicle battery.
a) Mobile device
Check the input voltage of the device you intend to charge via the USB-A
chargingport (7). Make sure the total loading does not exceed the rated output of
this charger.
• Using a USB cable (not included), connect the USB charging port on your mobile device to
the USB-A charging port. Charging will begin automatically.
b) Earpiece
Insert the earpiece into the receptacle to begin charging.
Earpiece
a) LED
Colour
Status
Red / blue
Alternate flashing
Red / Blue
Off
Red / Blue
Flashing 3x every 5 sec.
Blue
Flashing
Blue
On
Red
Flashing
Red
On
b) Bluetooth pairing
1. Turn the earpiece off by pressing and holding the multifunction button (6) for approx. 5 sec.
A voice will prompt "power off".
2. To enter pairing mode, press and hold the function button for approx. 1 sec until the voice
prompt "power on" is heard. The earpiece LED (8) will alternate red and blue.
3. Open the Bluetooth menu on your mobile device and select "RF-CCB-200":
- If pairing is successful, a voice prompt "the headset is connected" will be heard and the
earpiece LED will turn solid blue.
- If pairing is not completed within 180 sec, a tone will sound, and the headset will enter
standby mode. Approx. 120 sec after entering standby mode, a voice prompt "powered
off" will play, and the headset will power off.
c) Sleep mode
• If the earpiece is powered on and placed into the receptacle (3), it will enter sleep mode.
The earpiece LED will light red for one second then turn off.
• Removing the earpiece from the receptacle will exit sleep mode and automatically
re-connect to a previously paired device.
2
3
4
5
7
5 Microphone
6 Multifunction button
7 USB-A charging port
8 Earpiece LED
Description
Open for pairing
Not in receptacle, powered off or no
batteries.
Anti-lost warning
Pairing complete
Fully charged
Low battery
Charging
6
8

Publicité

loading

Ce manuel est également adapté pour:

2176934