Delta MultiChoice T27T Serie Instructions D'installation page 5

3
Trim Installation
A.
3
4
5
Escutcheon Installation
For finished walls up to 1 1/8". Install trim sleeve
(1) over valve cartridge (7) and bonnet. Secure
backplate (2) to rough-in body using 4 screws (3)
provided.
Note: Be sure backplate is oriented front side
forward and markings are visible.
Holding escutcheon (5) in place, thread trim nut (4)
onto diverter sleeve (6).
Note: For thick wall installations, order
installation kit RP90544 to support finished
wall thickness up to 2 1/8".
On rough or uneven surfaces it is necessary
to apply caulk around the backplate (2) to
supplement the seal. Do not caulk the drip notch
in the bottom of the backplate (2). Do not caulk
the escutcheon (5).
Installation and Adjustment of the Temperature Knob
Failure to do so may cause injury.
C.
3 2
1
4
Adjust temperature limit stop
Turn on water supplies; LET THE WATER RUN AT
BOTH FULL HOT AND FULL COLD TO ENSURE
THE WATER IS RUNNING AS HOT/COLD AS
POSSIBLE. Place a thermometer in a plastic tumbler,
and hold the tumbler in the water stream. Place the
temperature knob (1) onto the splines (2), then rotate
the temperature knob counter-clockwise until you
achieve your maximum desired temperature from the
outlet (not more than 120° or the lower temperature
mandated by your local plumbing code).
If max temperature is not achieved before limit
6
2
1
3
B.
1
7
Volume Handle Installation
Install valve handle (1) over cartridge (4), screw in
set screw (2) using a allen wrench.
Place set screw cover (3) over set screw and apply
pressure until cover is properly seated.
4
stop (3) on temperature knob (1) meets the limit
stop (4) on the volume control handle. Remove
the temperature control knob (1) from splines (2).
Rotate temperature control knob (1) clockwise.
Place temperature control knob (1) back onto splines
(2) and continue to rotate counter-clockwise until
maximum desired temperature is achieved.Remove
the temperature knob (1) and replace onto thesplines
(2), making sure that the temperature knob limit stop
(3) hits against the volume handle limit stop (4) as
shown.
5
Installation
3
2
4
3
84893 Rev. D