Publicité
Les langues disponibles
Les langues disponibles
Fax +32 2 359 95 50
position. Do NOT use the burn of steam function when the steam
press is closed, or you may damage the unit.
Do not press the burst of steam button (6) for more than 5
•
seconds or water may drip on your garment.
The handle (1) is equipped with 2 steam burst buttons (6), in order
•
for the press to be used easily by right-handed or left-handed
people.
PRESSING
Make sure the locking knob (5) is in the open position (UNLOCK).
•
Lift the handle (1). The pressing plate (2) moves to the up position.
•
Carefully arrange the garment to be pressed onto the ironing
•
board (3).
Note: Avoid contact with the hot plate at any time!
Grasp the handle of the pressing plate (2) and lower it onto the
•
ironing board (3), capturing the garment between the two halves
of the steam press.
For lightly creased garments, simply lowering the handle and
•
allowing the pressing plate to rest on the ironing board for a few
seconds will be sufficient. Return then to the open position.
For very creased garments, continue to grasp the handle and
•
push it downwards completely, until the pressing plate is pushed
to its lowest position. Then open the press.
If the temperature is set high enough you may give the fabric a
•
burst of steam by pressing the burst of steam button (6) to
remove stubborn wrinkles.
Caution: For bursts of steam, lower the pressing plate until it is about
two inches from the garment, not completely down! Press the burst
of steam button for about 3-5 seconds. After releasing the burst of
steam button you may fully lower the pressing plate.
Note: Do not press the burst of steam button when the pressing plate
is in its lowest (closed) position.
After a few seconds, lift the handle and bring the pressing plate
•
back to the raised position.
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
7
Assembly page 7/35
special
instruction
from
Team
Print only
STP 30138 - 120501
Publicité
