Kalorik STP 30138 Mode D'emploi page 10

Fax +32 2 359 95 50
TROUBLESHOOTING
PROBLEM
Steam press cannot be
opened with the
handle
Steam press becomes
warm but DOES NOT
remove wrinkles.
Press DOES NOT get
warm.
No Steam
Water drips from the
pressing plate.
The handle will not
move into the
automatic maximum
pressure position
(handle completely
down).
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
CAUSE
Locking knob is in
locked position
Temperature setting is
not high enough for the
fabric; the piece of
garment is too dry.
Temperature has not
been selected
Press is not plugged
into an outlet.
Automatic Shut-Off is
engaged. The pressing
plate has been left
open for more than 15
minutes (or closed for
more than 10 seconds)
Water Level is too low.
Temperature is set too
low.
Burst of steam button
has been pressed too
long.
Item on the ironing
board is too thick
10
Assembly page 10/35
special instruction from Team
Print only
SOLUTION
Turn the locking knob
to the unlocked
position
Gradually increase the
temperature until
obtaining the desired
results; spray water over
the piece of garment.
Make a proper fabric
selection.
Plug the appliance in.
Press "ON/OFF" again.
Fill the water tank.
If suitable for the fabric,
make a selection to a
higher temperature.
Wait for the steam
ready light to come on.
If not, use spray bottle
as directed.
Do not press the burst
of steam button for
more than 5 seconds
continuously.
Keep one hand on
handle and exert light
pressure on thicker
items. Burst more steam
for wrinkles.
STP 30138 - 120501