I.SOUND IGLOWSOUND WAVES Guide De L'utilisateur page 5

ADJUSTING THE VOLUME
You can adjust the volume on your Bluetooth-enabled device and on iGlowSound
POWER BUTTON LED INDICATOR
LED off - Power off
LED solid green – Power on
LED red – Battery needs to be charged
POWER BUTTON LED INDICATOR (WHILE CHARGING)
LED red – Battery is charging
LED green – Battery is fully charged
BLUETOOTH LED INDICATOR
LED flashing blue (rapid) - In Bluetooth pairing mode
LED flashing blue (slow) – Bluetooth is paired with your device
TROUBLE SHOOTING
Problem: The sound is low or completely silent.
Solution: Make sure both your audio device and iGlowSound
(either AUX or Bluetooth) is fully functioning and secure. If using auxiliary, be sure the cable is free of dirt and debris and is
securely inserted into iGlowSound
the volume on both your audio device and iGlowSound
playing music.
Problem: Bluetooth will not connect or you cannot figure out how to connect it.
Solution: Please consult the User Guide of your Bluetooth enabled audio device for instructions. Make sure that both your
audio device and iGlowSound
back on. Make sure someone else is not already connected to iGlowSound
FCC WARNINGS
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum 20 cm between the radiator and your body. This transmitter must not be collocated or
operating in conjunction with any other antenna or transmitter unless authorized to do so by the FCC.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
waves and your audio device. Also make sure the audio cable is not damaged. Check that
™
waves are discoverable and in search mode. Try rebooting the speaker by turning it off then
™
waves are charged. Make sure the connection
™
waves is up to at least medium. Confirm that your audio device is
™
waves.
™
waves.
™