I.SOUND IGLOWSOUND WAVES Guide De L'utilisateur page 3

CHARGING IGLOWSOUND™WAVES
Charge iGlowSound waves with the included USB charge cable. Plug one end into the rear of iGlowSound
™
the other end into a powered USB port like on a computer.
If you need a USB AC adapter or car charger, please visit
www.isound.net and search for item numbers: ISOUND-2102 or ISOUND-2104.
PLAYING MUSIC VIA BLUETOOTH
1. Make sure that iGlowSound™waves is charged.
2. Turn iGlowSound waves on by pressing the power button on the top. A green LED will illuminate and blue LED will
™
begin flashing.
3. Follow the instructions for pairing that came with your Bluetooth enabled device. You may have to go into your settings
and turn Bluetooth ON. Make sure your device is discoverable or in search mode.
4. Your device should discover "iGlowSound
NOTE: Once you are paired, the blue LED will blink slowly.
5. You are now connected and can play your audio content wirelessly!
USING THE SPEAKERPHONE FEATURE
Before using the Speakerphone feature, connect your device via Bluetooth.
1. When a phone call comes in, answer it as you normally would on your phone. Or, press the Speakerphone button.
2. Speak into the microphone located on the top of iGlowSound
3. Your caller's voice will play through iGlowSound
4. To end speakerphone mode at any time during your call, press the speakerphone button. Or, when your call is over, hang up
as you normally would on your phone.
MICRO USB
CHARGE PORT
®
MODE
waves." Select this profile. If a password is required, type "0000."
™
waves's speakers.
™
"AUX OUT"
"AUX IN"
waves.
™
waves (5V IN) and
™