HomeTech EF494 Guide D'installation Et D'utilisation page 5

Instructions for Use

The appliance can be operated either by the switches located on the top right hand side of the fire
or by supplied remote control.
Manual Operation

The switch is located at the lower left side of the fireplace. The standby switch must be
switched on first.

Press once the button
appear to indicate that the function is ON. Press the button
the dimmer mode.

Press once the button
setting.

Press once the button
setting.
Remote Operation

Please take off the insulation sheet before you use the remote.

The standby switch located at the top right hand side of the fire must be first switch on.

It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons more
than once within two seconds for correct operation.

Press once the button
effect.

Press once the button
setting.

Press once the button
setting.

Press the button
Safety Cut-Off

This appliance is fitted with a safety cut-off which will operate if the fire overheats (eg. due to
blocked air vents). For safety reasons, the fireplace will NOT automatically reset.

To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect the supply to the mains and switch on the appliance.
No operation/ no fan.
No fire effect light.
OPERATING INSTRUCTIONS
to turn on the appliance and fire effect. A red indicator light will
for the low heat settings (750W); press twice to switch off the heat
for the high heat settings (1500W); press twice to switch off the heat
on the remote control this turns ON/OFF the appliance and fire
for the low heat settings (750W); press twice to switch off the heat
for the high heat settings (1500W); press twice to switch off the heat
to operate the dimmer mode.
SAFETY FEATURES
TROUBLESHOOTING
Symptom
for 3 seconds this will operate
Solution
Check for safety cut-off operation.
Check the bulb by replacement.