Maintenance; Clearing A Jam; Tool Repair And Replacement Parts; Assembly Procedure For Seals And Moving Parts - Campbell Hausfeld NF349099 Instructions D'utilisation

Operating Instructions and Parts Manual

Maintenance

CLEARING A JAM

ALWAYS wear ANSI Z87 compliant safety glasses when using tool
or making any adjustments or repairs.
If the tool becomes jammed, do the following to clear
the jam:
1. Remove the fuel cell and battery from the tool (see Figure 26).
2. Pull the fastener pusher to the bottom of the magazine and remove all remaining
fasteners from the magazine (see Figure 27).
3. Remove the socket head cap bolts with allen wrench (see Figure 28).
4. Pull magazine away from head assembly (see Figure 28). Remove the jammed
fasteners.
5. Return head assembly and magazine to original position. Insert and tighten socket
head cap bolts.

TOOL REPAIR AND REPLACEMENT PARTS

Only qualified personnel should repair the tool and they should use genuine Campbell
Hausfeld replacement parts and accessories, or parts and accessories which perform
equivalently.
Use only genuine Campbell Hausfeld service parts. Tool
performance, safety, and durability could be reduced if improper
parts are used. When ordering replacement parts, specify by part number.

ASSEMBLY PROCEDURE FOR SEALS AND MOVING PARTS

When repairing or servicing a nailer, the internal parts must be cleaned and lubricated. A
compatible lubricant must be used on all o-rings. Each o-ring must be coated with the
lubricant before assembling. A small amount of oil must be used on all moving surfaces
and pivots. After reassembling, a few drops of 30W non-detergent oil or equivalent,
must be added one time before normal operational use.

AIR FILTER

Open fuel cell door. Remove air exhaust cover (grille) by pressing on grille and turning
grille slightly out toward the top of the tool. The filter is held in place by the grille; filter
should lift out of place easily (see Figure 29). Remove all large particulates from the
grille and wash with a mild soap and water. Check and clean the filter on a regular basis
before and after regular use. We recommend cleaning the filter every other day and
before and after tool is placed in storage for any long period of time.

STORAGE

Store tool properly with fuel cell and battery removed.
Remove all fasteners from the tool.
◆
Store nailer in a cool, dry location. Do not store in a warm location or a location that
will possibly increase to temperatures above 120°F (49°C).
◆
Make sure stored tool is out of the reach of children; use storage case to help
secure the tool. Use storage case to store components of tool separately.

TECHNICAL SERVICE

For information regarding the operation or repair of this product, please call
1-800-543-6400.
Figure 26
Figure 27
Figure 28 Figure 29
Grille
Filter
Figure 29
www.chpower.com
NF349099
Press here
to remove
grille from
tool
11