Digigram IQOYA TALK Mode D'emploi page 3

Step 2: Click on the Audio Set-
tings button
1. Adjust the audio levels of the
input and output peripherals
connected to IQOYA TALK.
The "Phantom" option is turned
off by default for all the mi-
crophones. Simply toggle to
option to "ON" to activate it.
Please note that the "HP3"
(Headphone 3) tab under the
"Outputs" tab lets you control
both headphones adjacent to
MIC 3 simultaneously.
Step 3: Click on the Mixers but-
ton
Each of the outputs have a sepa-
rate Mixer that allows you to easily
adjust audio routing, change input
audio levels and master volume.
1. To edit the default mixer set-
tings, click on one of the output
option tabs (HP1, HP2, HP3,
Aux & Program TX) and select/
deselect a crosspoint in the
Mixer under any of the input
3
sources of choice.
2. To change the audio level of
each of the input sources, sim-
ply click on the "Volume-control"
icon under the name of the
source to access the volume
slider.
3. To adjust the master volume,
click on the "Master" button
placed in each of the output
tabs.
Step 4: Click on the Live button
1. Select the respective contacts
and audio profiles for "PRO-
GRAM" and "TALKBACK" by
clicking on the "Studio" but-
tons adjacent to them.
2. If needed, fine-tune the mic
input gain for all three MIC LINE
inputs by tapping on "Talent 1",
"Guest" or "Talent 2" placed on
the bottom half of the screen.
ESTABLISH THE CONNECTION
Once the device is configured, the
connection is simply established
as follows:
From the home menu, click on the
green «Live» button for the first
time to access the «live» menu.
Click on the green «Call» button
on the left to initiate the «Program»
call.
To establish the «Talk Back»
connection if necessary, press the
«Call» button on the right.
The button(s) will turn
throughout the duration of the
connection.
To hang up, click on the red button
and confirm.
To record audio in IQOYA TALK's
internal memory, click the «Re-
cord» button on the bottom left cor-
ner of the screen.
You can change the title of the re-
cord by clicking in the tab to the
right of the record button (by de-
fault TAKE1). Click X to erase the
pre-defined text, enter the new text
and confirm with ENTER.
All levels can be set during the live,
by pressing «Talent 1», «Guest» or
«Talent 2» placed in the lower half
of the screen.
red
4