Bandalux Roller Mode D'emploi page 51

7. Programming a motor from the start
7.3 Regulating the ends of the track
Press «Roll up» or
Press «P2» from Short press of the Press «P2» on
button «Roll up» on «Roll down» until the
the remote control. the remote control.
the remote control. end of the desired
top rail.
or
The motor responds
The motor responds The motor responds
x1 x1 x1 x1 x1 x4
Press «Roll up» or
Press «Stop» 5 times from Press «Stop» 5 times from
«Roll down» until the end
the remote control, just at the the remote control, just at the
desired top end of the rail of the desired lower rail. desired lower end of the rail
EN
or
The motor responds The motor responds
x4 x1 x4 x1
x1 x1
When the shade is near the desired top or bottom end of rail, press «P2» and the shade will begin to move slower.
If we exceed the desired top or bottom limit switch, press «Roll up» or «Roll down» and the shade will change direction
of the operation, it will continue moving slowly.
51
GENERAL PROGRAMMING, RADIO BATTERY MOTORS AND C.C. INTEGRATED TRANSFORMER BANDALUX