Assigning Remote Control; Checking Direction Of Rotation - Bandalux Roller Mode D'emploi

7. Programming a motor from the start

7.1 Assigning remote control

Power the motor
(only for C.C
integrated motor)
7.2 Checking the direction of rotation
Press «Roll up» or «Roll
down» to check the direction
EN
of rotation.
Press «Prog.» from
the motor head
(approx. 2 sec)
or
The motor responds
x1 x1
50
GENERAL PROGRAMMING, RADIO BATTERY MOTORS AND C.C. INTEGRATED TRANSFORMER BANDALUX
Press «Prog.» from Press «P2» on
the motor head the back of the
(approx. 2 sec) remote control.
or
The motor responds The motor responds The motor responds
x1 x1
Press «P2» on
the back of the
remote control.
The motor responds
x1 x1
Press «P2» on
the back of the
remote control.
x1 x1
or
Press «P2» on
the back of the
remote control.
The motor responds
x1
Short press of the
button «Roll up» on
the remote control.
The motor responds
x1 x1
OK !!!
Go to point 7.3
NOT OK !!!
Short press of the
button «Roll down»
on the remote control
The motor responds
x1 x6
x6