Lubrication And Maintenance - Uline H-3068 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

1. Lubricate the stapler prior to initial operation.

2. Disconnect the stapler from the air supply prior to servicing.

3. Turn the stapler so that the inlet is facing up and put one drop of high-speed spindle oil, UNOCOL RX22, or 3-in-1

oil, into air inlet. Never use detergent oil or additives.

4. Operate the tool briefly after adding oil.

5. Wipe off excessive oil at the exhaust. Excessive oil will damage the O-rings. If inline oiler is used, manual

lubrication through the air inlet is not required on a daily basis.

AIR SUPPLY AND CONNECTIONS

NoTe: The following illustration shows the correct mode of connection to the air supply system which will

increase the efficiency and life of the stapler.

Many air tool users find it convenient to use an inline oiler to provide oil circulation through their tool. Check oil level

in the oiler daily.

A filter is recommended on your air compressor. Check the filter and drain on a daily basis.

Air Hose

Quick Connector

Quick Coupler

SETTING THE CORRECT PRESSURE

Necessary pressure will vary, depending on the material to be stapled and the staple size. Do not use more air

pressure than is required. To determine the best setting, start at low pressure and increase pressure until drive

is satisfactory. Using excess pressure increases tool wear on the plier and wastes compressed air.

WARNING! do not use oxygen or combustible gases as air supply sources. exceeding 200 psi is dangerous,

as tool may explode.

PAGE 6 OF 28