Evenflo FlexLite PRO Mode D'emploi page 10

USING YOUR STROLLER
5B
5-pt Harness
G
H
K
J
Step 1
G
I
3-pt Harness
K
J
8
H
G
I
K
Step 2
G
H
I
K
To avoid serious injury from falling or sliding out, ALWAYS use
Note: Verify the in-seat fold locks on both sides are locked by lifting up
the rear of the stroller using the parent's handle.
Lock the rear brakes and pivot the child's tray out of the way.
5-point Harness:
With the 5-point harness, the harness shoulder straps G must start at
shoulder height or lower, as shown, and use the harness strap loops
H closest to the baby's shoulders. To adjust the height of the harness
shoulder straps to the baby's shoulder height, do the following:
1. Remove each harness shoulder strap G from each buckle I, as
shown.
2. Thread each harness shoulder strap G under the harness strap loop
H that is closest to the baby's shoulder.
3. Reattach each harness shoulder strap G to each buckle I.
5-point and 3-point Harnesses:
Place the baby in the seat and bring the crotch panel J up between
the child's legs. Fasten each buckle I. For a snug, comfortable fit,
pull the shoulder straps G to tighten the shoulder restraint (shoulder
restraint only for 5-point harness) and pull the waist restraint straps K
to tighten the waist restraint.
Note: To loosen the waist straps K, push in the release button L on the
buckle and pull.
Once the child is properly restrained, close and lock the child's tray.
Make sure the tray locks into position with audible clicks. Pull on the
child's tray to make sure it is locked into place.
To change from 5-point to 3-point harness:
Remove each harness shoulder strap G from each buckle I, as shown
above.
L
WARNING
waist restraint.