Disposal - Zipper Maschinen ZI-HAEK4000 Manuel D'utilisation

 Slowly pull the start handle until the resistance is reached, then stop pulling. At that point, the
valves are closed, that will prevent dust and rust from entering the cylinder.
• Store in a dry, out of reach of children place, well packaged.
14.1.11

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. Avoid damage caused by leaking
operating supplies: drain the operating supplies prior to disposal! When you buy at your
local dealer for a replacement unit, the latter is obliged to exchange your old.
15 TROUBLE SHOOTING
Shut off the machine, let it cool down, disconnect spark plug cap from spark plug
Trouble
Engine does not start
To low power
No automatically
feeding of the
shredded material
Machine vibrates or
makes unusual noises
Engine overheats
Chips do not come out
of the discharge
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HAEK4000
ATTENTION
Possible cause
 Ignition switch defect
 Engine switch OFF
 No fuel, or fuel is old and
stale
 Engine oil is low
 Spark plug dirty or damaged
 Fuel line faulty
 Air filter dirty
 V-belt
 Overload
 Blockage
 Blades blunt
 Blades blunt
 Screws, nuts or other parts
are loose
 Impeller or blades have
woody residue or chucks
stuck to them
 Chips and sawdust around
the engine
 Air filter dirty
 Discharge chute or hopper is
clogged.
 Repair or change
 Set the engine switch to ON
 Refuel
 Add oil
 Clean or change
 Check fuel line for damage and
kinks
 Clean or change
 Tighten or change
 Reduce material feeding
 Remove shredded material
 Replace/ sharpen blades
 Replace/ sharpen blades
 Fix parts
 Clean the impeller and blades
 Clean the engine surface
 Clean or change
 Turn of the engine, disconnect the
spark plug, then clean out the
machine
NOTICE
TROUBLE SHOOTING
Solution
29