Team Electronic CB Mobile MiniCom Full Multi Norm DE Mode D'emploi page 7

TABLE OF CONTENTS
Elements
Setup
Installation of a CB antenna
Aerial Connection
Installation in the car
Microphone
Power source
Operation
On / Off [VOL]
Squelch [SQ/ASQ]
Channel selection [UP] [DN]
Modulation selection [A/F]
Scan [A/F]
Norm selection
Transmitting
Priority Channels 9 / 19 [EMG]
Key lock [EMG]
Receipt-Signal Sensitivity [RFG]
External speaker jack
Internal s-meter
Additional Information
Safety Instructions
General Precautions
Servicing
Conformity
Channel Frequencies
Specifications
12
Installation of a CB antenna
2 The antenna is one of the most critical parts in the setup. The type
of antenna and its location has a great effect on the range of opera-
tion. Please consider the following criteria for selection of the best
13 location and the installation of your antenna:
14
> Make sure that the antenna is designed for radio operation on 27 MHz.
14
> The position of the antenna should be elevated without any
14
obstacles nearby.
15
> The aerial cable should not be damaged and the plugs should be
properly connected.
> Make sure that the antenna cable is not bent.
16
> The bigger the mechanical size of the antenna, the higher the
16
range of operation.
16
When you install a mobile antenna please note the following advices:
16 - 17
17
> The antenna should be fixed in the center of a big body-part, e.g.
17
the trunk.
18 > The mobile antenna coil should have the closest possible contact
18 with a conducting metallic surface of the bodywork of the car.
18
There are other possibilities to fix the antenna onto the car without
18
having to drill a hole into the bodywork of your car, e.g. mounting the
18
antenna with a antenna holder onto the gutter or the trunk. Magnetic
18
mount antennas (with an magnetic base) or windshield antennas,
which are glued onto the glass, are also alternatives.
19
> Please don't mount the CB antenna nearby a radio or TV antenna
19
to prevent interference of radio or TV reception.
19
> DANGER: Keep an eye on power lines running along nearby when
19
mounting the antenna on the roof.
> All connected cables including the antenna cable must not exceed
51
a length of 4.5 m.
27
SETUP
13