Publicité
Les langues disponibles
Les langues disponibles
How to use
NOTE
Before use, make sure the breast pump has been properly installed and all its pieces which come into contact with
milk are disinfected. Wash hands. While using, press the breast pump against the breast tightly to avoid air suction.
1.
Switch the device on, short press the on/off switch. The device will activate milk stimulation mode
(massage) automatically.
2.
The mode ends automatically after 3 minutes. You can also change the mode manually before 3
minutes expires. To do so, press the mode switching key (fig. 2).
3.
The milk stimulation mode: 5 levels are available. You can change massage level by pressing level
up or down keys (fig. 2).
4.
Milk drawing mode: 9 levels are available. You can change the suction level by pressing level up or down keys (fig. 2).
Selection of a suitable and comfortable level is very individual and depends on the suction power. It is advisable
to use the breast pump in the milk drawing mode directly after the milk stimulation mode.
The device deactivates automatically after a default working time: 30 minutes.
How to store and heat up milk
How to store
1.
After collecting milk, tightly close the container and put inside the fridge.
2.
Milk can be stored for up to 4 hours in the room temperature (16-29°C).
3.
Milk can be stored for up to 48 hours in the fridge (4°C).
4.
Milk can be stored for up to 3 months in the freezer (< -4°C ).
How to heat up
After defrosting or taking out of the fridge, use the heater to heat the milk and serve for feeding. Do not use
a microwave or boiling water to heat it up because milk may lose its nutritional properties.
NOTE
1.
To freeze milk, make sure ¾ of the container is filled because frozen milk expands.
2.
To maintain nutritional values of the milk while defrosting, at first place the milk in the fridge, and
then heat up with warm water at the maximum temperature of 37°C.
3.
Do not use microwave or boiling water to defrost milk to avoid loss of nutritional properties.
4.
Never try to freeze milk again if it has already been defrosted.
5.
Never add fresh milk to frozen milk.
6.
Before you start breastfeeding, gently shake the milk container to mix it properly.
How to charge
1.
The breast pump has a built-in battery.
2.
When the battery is low, battery symbol will show one bar. In such case it is advisable to charge the device.
3.
Connect USB cable to breast pump USB power supply and the other tip to the USB power adapter
(not supplied).
4.
When the battery is full, battery symbol glows and shows three bars.
5.
You can use the breast pump while charging the battery, but please remain very careful.
Troubleshooting
Problem
Device does not work
Insufficient suction
power
Solution
• Check battery status
• Start charging the device
• Make sure the device has been correctly connected to charging source
• Make sure the suction valve is correctly installed
• Place the valve in boiling water, leave for 3 minutes and then fix again
• Make sure battery level is sufficient
• Make sure the breast pump adheres to the breast tightly
• When temperature in the room is lower than 15°C, leave the working
device for about 30 seconds before you start using it.
‑ 7 ‑
EN
Publicité
